Hello Crafty Peeps,

We are making a colorful shaker card with a bit of a twist. Instead of the shaker in the middle of the card it is the frame of the card that is the shaker!

First, is stamping the card front. Using the sentiment and the squiggles from the Kat Scrappiness stamp set Crafters Gonna Craft line up the images and stamp. I used three squiggles because it filled the card nicely. I then stamped and cut out three markers from the stamp set and colored the tips to match the squiggles.

Next I used the Kat Scrappiness Never Ending Rectangle dies to cut a frame for the card center and another frame for the outside edge of the shaker card. These were cut from black card stock.

The markers are attached to the card center matching colors. Any marker hanging off the card is snipped off. The frame was attach.

The other black frame is adhered to the Kat Scrappiness A-2 Acetate Sheet. Next the center card front is attached to the center of the acetate layer.

Using foam tape along the entire edge of the card (backside of the card front under the frame) place foam tape. Place a second row of foam tape around the center card creating a trough for the shaker elements. I used Kat Scrappiness Cake Sprinkles for my shaker bits. These bits were placed into the trough.

Final step is to attach the card front with shaker bits to the card base.

I hope this inspires you to make a shaker card. Enjoy!

Kat Scrappiness supply list:

Kat Scrappiness “Crafters Gonna Craft” Stamp set

Kat Scrappiness Never Ending Rectangle dies

Kat Scrappiness A-2 Acetate sheets

Kat Scrappiness Cake Sprinkles

Error: Contact form not found.